3
Cross Cut
Place the flooring plank onto the cutter
base and position the stopper in the
appropriate slot at the required length.
Then push down the blade by using the
handle. The cutter is designed to cut
through laminate pieces by removing a
small amount of laminate.
Please note that a slightly rough edge
is normal. The cut edge will meet the
wall and be covered by a molding (a
base board or a quarter-round).
The Slot on the Cutter Base
On the cutter base, there are a few sets
of the slot used for the stopper
attachment. Always use the slots closer
to the pivot of the blade according to
the width of the plank. The closer to the
pivot of the blade, the more cutting
power you will get.