2
Handle Assembly
Insert the handle to the handle base
and use the provided screw / washer
/ spring washer as shown.
Straight Cut
Insert the floor plank between the
cutting blade and the base, flush
with the guide bar on the working
table and hold the plank then pull
handle down to complete a cut.
Warning:
Maintain control of the
handle. Do not allow handle to slam
back after making a cut.
Changing the Blade
Use provided Allan wrench to
remove the four screws, and then
move the blade out of the blade
holder.
Note:
the flat side of the blade
should face the working table.
Warning:
Do not put your fingers
against the sharp edge of the blade
at any time.
