JF-1A Conductivity Sensor
A440-010
December, 2005
11
Figure 5
INSTALLATION DRAWING
ATTENTION!
Prior to performing the next steps ensure product line
pressure is less than 150 psia (10.0 Bar).
4. Turn ball valve handle 1/4 turn to open.
5.
Turn “black” locking mechanism counter-clockwise to loosen
shaft.
WARNING!
Do not rotate the main body (electronics housing) other than
in a clockwise direction to assist the sensor in sliding it down into the
product line, counter clockwise rotation could result in damage to the sensor
tip.
PDF created with pdfFactory trial version
