Czaki EMT-200, Operating Manual

Page: 5 / 24

2.1.Description of display functions
Switching on the meter results in displaying the „ LOAD ” message on
the main display. It means starting the meter.
In the basic mode the display presents temperature in
degrees Centigrade. The unit of measurements is shown on the
auxiliary display..
In the programming mode the main display shows
consecutive positions of menu or parameter names, and the
auxiliary display presents their respective values..
If the LED „ALARM 1” or / and „ALARM 2” comes on it
means that the measured temperature has entered the
programmed alarm range.
While modifying (meter) parameters the value indicated in
the active field of the auxiliary display is also changed. The
active field is distinguished by blinking of selected position.
If the main display shows the „ ERR ” message it means that
the processing range has been exceeded, a sensor has been
incorrectly connected, or the sensor previously programmed
differs from the sensor actually connected.
2.2.Using keyboard
The meter is equipped with the three key membrane keyboard..
The key „ p ” is used for changing the value of the active
(blinking) digit. It is also intended for entering the parameter
programming mode and for leaving this mode.
The key „
u
” makes possible changing the menu position
and changing the active digit.
The key „ tu ” is intended for confirming the selected menu
position, or for confirming the (selected) value.
5