Czaki EMT-200, Operating Manual

Page: 11 / 24

Completed changes should be confirmed by „
tu
” (Factory settings will
be recorded in the meter memory).
Depressing „ u ” we can go to the next menu position.
Depressing „ p ” we leave „ RSCT ”, depressing „ p ” again we come
out of the programming mode and we enter the temperature
measurement mode.
5.3. Recording results
Determining whether measurement results should be recorded in the
meter memory.
Using „ u ” select „ TMEM ” position in the programming „ MEMO ”
mode.
The auxiliary display indicates the current value of the parameter. To
change it depress „ tu ” (the digit on the auxiliary display will start
blinking).
Using „
p
” set the required value.
The parameter can assume the following values:
!
0 results are not recorded,
!
1 storing in memory consecutive 300 measurements with frequency
determined by „ RSCT” (see item 5.1 ),
!
2 storing in memory consecutive measurements. After memory
overflow measurements are shifted “upwards” (the first position is
deleted, and the (latest) result is recorded in the last position.
ATTENTION : When the parameter value is 1 the first position of the
auxiliary display presents symbol Ï . It means that recording results in
memory is in progress.
The symbol comes off after recording 300 (results of) measurements.
Completed changes should be confirmed by „
tu
” („ TMEM ”
message would start blinking again). Depressing „
p
” we come out of
„ TMEM ”, depressing „ p ” again we leave the programming mode and
enter the temperature measurement mode.
11