Cyrusher 866, User Manual

Page: 6 / 26

Cyrusher Sports Team
www.cyrusher.com
info@cyrusher.com
6 / 26
setting, however, the speed limited setting is controlled by motor and controller. You can only
set the bike computer speed limit with the range of limit motor and controller. For example,
if the motor and controller speed limit is at 40KM/H, you can only set up lower top limit such
as 35KM/H, If you set 50KM/H, the real top limit is also only 40KM/H;
P09: Zero boost or Non Zero boost. Range: 0 means zero boost; 1 means non zero boost.
In the zero boost also called hart boost which means, once you use the throttle or pedal
assistant, you get will push from the motor immediately; In non-zero boost, you have to use
pedal first to move the e-bike to some certain speed and the throttle or PAS will be active.
P10: Driving modes; Range: 0
– PAS only, the throttle is not working; 1 — throttle only, PAS is
not working, 2 — both throttle and PAS are working;
P11: PAS sensitivity setting, Range: 1-24, this technical setting is no use for customer but only
for engineer setting, please do not modify or change the setting.
P12: PAS strength setting, Range: 1-5, this technical setting is no use for customer but only
for engineer setting, please do not modify or change the setting.
P13: PAS magnetic sensor setting, Range:
5/ 8
/
12,
this technical setting is no use for customer
but only for engineer setting, please do not modify or change the setting.
P14: Controller Max current limit setting. Range: 1-20A;
P15: Controller Low voltage setting. Range: N/A, need to check with controller technical data
sheet;
P16: ODO, total
odometer clearance setting. Press for 5 seconds in setting mode,
you can change and clear the current total odometer to Zero.
P17: Cruise control setting. Range: 0
— inactive cruise control mode, 1 — active cruise control
mode (optional); ;
P18: Speed adjustment setting, Range: 50%-150%, this technical setting is no use for customer
but only for engineer setting, please do not modify or change the setting.
P19: PAS 0 setting. Range: 0
— active PAS 0; 1 — inactive PAS 0;
P20: Data transfer mode setting. Range:0
— NO.2 data transfer mode; 1 — 5 S data transfer
mode; 2 — backup data transfer mode; 3 — backup data transfer mode;