TROUBLESHOOTING
Cyrus aCA7
English
16
Spurious Sounds from the Loudspeakers
If you experience strange or unnatural noises from your
system proceed as follows:
•
Select another source to ensure that this is not a
common problem. If the problem remains, switch the
Cyrus aCA7 off at the mains or disconnect the mains
plug. Replace the mains plug after a few seconds and
restore power to the Cyrus aCA7. If the fault persists
or you are in any doubt, consult your dealer.
•
If the problem is limited to a single source, check the
integrity of the interconnection to the source and in
the case of a phono turntable, check that the phono
ground wire is secured at the rear panel of the
associated cartridge pre-amplifier.
FAULT INDICATION SYSTEM
The Cyrus aCA7 has a fault indication system to help you
to diagnose the cause of a problem. Fault indications are
presented by the Standby light on the front panel.
•
Flashing RED
There is a problem with the internal power supply of the
Cyrus aCA7. Switch the unit off at the mains and switch
on again after a few seconds. If the indicator still flashes,
return the unit to your dealer for attention.
Fault Indications involving PSX-R connections
•
Flashing RED
A PSX-R that is switched off is connected to the Cyrus
aCA7.
A PSX-R has been disconnected while the Cyrus aCA7 is
operating.
There is a fault with the internal power supply of the
Cyrus aCA7.
•
Flashing Green
A PSX-R has been connected while the Cyrus aCA7 is in
normal operating mode.
In all the above cases you should switch all units off, fully
disconnect the PSX-R, and switch on the aCA7 again.
If normal operation resumes, switch the Cyrus aCA7 off
and re-connect the PSX-R following the instructions on
Page 5 of this manual. The system should now work
normally.
If the fault indications persist, return the suspect unit to
your dealer for attention.
Summary of Contents for aCA7
Page 1: ...User Instructions Cyrus aCA7...
Page 2: ...Cyrus aCA7 English...
