4
CLEANING
a
Using the wipes provided test a small area to make sure it does
not affect the mounting surfaces. Clean the installation surfaces free of dust/grease to
assure the two-sided tape adheres well.
3. MOUNTING CLIPS Mounting clips can be secured using the two-sided tape or
screws. DO NOT USE SCREWS FOR FASTENING TO ELECTRONIC DEVICES
AND SENSITIVE SURFACES.
CAUTION: Tapes may cause discoloration to some surfaces over time. Remove one
side of the tape liner and apply to the bottom of the clips. Apply pressure for 5 seconds
to assure adhesion. Place clips on the lightbars.
4. LIGHTBAR PLACEMENT Remove the second side of tape liner. Keep the tape
surface clean. Place the bars in the proper location by pressing on the clips for 5
seconds. CAUTION: Never press on the clear lens of bars. Lightbars will get
damaged! Note the direction
of the wires being routed to
the hub.
5. HUB Mount the hub using
screws or tapes. Plug the
lightbar connectors into hub
outlets. The plugs are
polarized and can only be
plugged in one direction.
6. CONTROLLER Use tape
to mount the controller in an
accessible location. Some
painted surfaces may get
damaged upon future removal
of the tape/controller.
7. POWER UP Plug the power supply into an AC outlet. The plug is polarized (one
blade is wider than the other) as a feature to reduce the risk of electric shock. This
plug will fit in a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact the factory or a qualified
electrician. Never use with an extension cord unless the plug can be fully inserted.
Do not alter the plug.
8. DC JACK Connect the DC power jack into the controller DC cord.
Operations
Turn the unit on and adjust the light angle by twisting the lightbars within the
brackets. Try several angles to achieve the desired results.
