Cypress S6E1C1 Series, Programming Manual

Page: 46 / 58

CHAPTER3: Serial Programming Connection
1. Serial Programmer
P E R I P H E R A L M A N U A L
46 S6E1Cx_MN710-00016-1v0-E, August 31, 2015
CONFIDENTIAL
Connection Example of Cypress MCU Programmer
The following shows a connection example of Cypress MCU Programmer.
 When Crystal oscillator is used as the source oscillation clock
Figure 1-2 shows a connection example of Cypress MCU Programmer when a crystal oscillator
is used as a source oscillation clock and Table 1-2 available frequencies and communication
baud rates.
Figure 1-2 Connection Example when Using a Crystal Oscillator
Table 1-2 Oscillating Frequency and Communication Baud Rate Available for Clock Asynchronous
Serial Communication
Source Oscillating
Frequency
Communication Baud Rate
8MHz 19200bps
16MHz 38400bps
24MHz 57600bps
RS-232C
driver
P03/SIN0_0
VSS
P60/INT15_1
VCC
INITX
P01/SOT0_0
Note: The pull-up resistance values shown are for example.
Select the most appropriate resistance values for each system.
MD1
MD0
Device



Serial write: 0
Serial write: 1
10kΩ
X0
X1



10kΩ



Serial write at UART
communication mode: 0
10kΩ
10kΩ
RS-232C
User system
Source
oscillation
clock