7. Operation Controls and Functions
The following sections describe the hardware components of the unit.
7.1 Front Panel
HDMI Out
HDMI Out
HDMI In
SYNC
HDMI Out
HDMI Out
EDID
Sys.Reset CEC On
8
7
6
5
STD TV
①
⑤
③
④
②
②
②
②
①
EDID Control switch: This EDID control switch is determined if you are going
to use the EDID from the display attached to output 1 or use an onboard
EDID. When select to TV, the EDID will attach to output 1 and send the
signal according to output 1's EDID. Therefore, it is suggested to put
lowest or the most compatitive display specification on output 1. When
selected to STD, the EDID will become onboard EDID which supports
video up to 1080p 50/60Hz and PCM2Ch for audio. The factory default
setting is in TV mode.
②
HDMI Output 5~8: These slots are to connect to the HDMI displays. When
more than one output is connected, the HDMI output play identical video
signal simultaneously.
③
HDMI Input: This slot is to connect to HDMI or DVI source equipment such
as DVD player or set-top-box for input video and audio sending.
④
Sync LED: This red LED will illuminate when the HDMI source signal is
connected to the output display.
⑤
System Reset/CEC ON: When switch to System Reset, the system will send
the internal CEC command to the display within 8~10 minutes to force
all the displays switch to HDMI port 1’s EDID. Meanwhile, the source CEC
Command will not functional to the system. When switch CEC in ON, the
CEC Command will be active according to each output display’s EDID.
4