Type “IPCONFIG” To show all IP configurations. To reset the IP, type
“RSTIP” and to use a set static IP, type ”SETIP” (For a full list of commands,
see the Section on RS232 and Telnet Commands above).
Note:
Any commands will not be executed unless followed by a
carriage return. Commands are case-insensitive. If the IP is changed
then the IP Address required for Telnet access will also change
accordingly
Web GUI Control
On a PC/Laptop that is connected to the same active network as the Matrix,
open a web browser and type device's IP address on the web address entry
bar. The browser will display the device's status, control and User setting
pages
