Page 4
5.2 Rear Panel
1. IR IN: Connect the included IR receiver cable and use the source(s) existing
remote control(s).
2. IR OUT: Connect the included IR blaster cable and place it in front of the
sources for infrared signal sending.
3. EDID Control Switch: Default setting is TV (downstream). In this mode the
PU-Q1H8C will search all output ports (starting at output 1) for the highest
video/audio settings connected to each of the outputs. The detection priority
of the matrix is v1.3 HDMI, v1.2 HDMI, DVI. Switch to STD (fixed EDID) if
you have any issues with the default setting (TV). When switching to STD,
please ensure that the unit is powered OFF, then ON again, for the setting to
be made. By changing to STD, this will force the source to be configured as
standard stereo (PCM) Audio and initiate a search for a common compatible
video resolution.
Note: When in STD mode the deep color is suggest to switch to 8-bit for longer distant display.
2CH/Multi CH – Supports 2 channels or Multi audio channels audio function. This selection is only
available when EDID is in STD mode.
Note: When Multi CH is selected TV/display must also supports Multi CH function otherwise, TV/
display will have no audio output. Unless, HDMI output connect to Amp and then to TV/display.
8/12 bit – Supports 8 or 12 bit’s deep color function. This selection is only available when EDID is in
STD mode.
Note: When HDMI output has both 8-bit and 12-bit displays, to ensure all output will display, switch to
8-bit.
On the other hand, when all output are with the same bit’s displayer of 12-bit or 8-bit then switch the
function to 12-bit or 8-bit will be proper. The splitter will not function according to different bits’ of
display on HDMI outputs simultaneously.
IR IN
IR OUT
SYS. Reset
OFF
ON
EDID
8 Bit 12 Bit
STD
TV
DC 5V
VIDEO
DDC
CAT6 IN
VIDEO 1
DDC 1
2
3
4
5
6
7
8
CAT6 OUT
HDMI OUT
8
7
6
5
4
1 2 3
