32
6.6.3 Network Tab
The Network tab provides controls over the Receiver’s broadcast reception
channel, IP configuration, and network broadcast mode. Changes made
to the network settings will require a reboot of the unit. After clicking on
“Apply” please follow the reboot instructions in the WebGUI.
Note: If the IP address is changed then the IP address required for WebGUI
access will also change accordingly. If the new address is assigned via “Auto
IP” or “DHCP” it might be necessary to temporarily disable the Video Link
between the Receiver and Transmitter in order to display the units’ new IP
addresses on the Receiver’s HDMI output. Press and hold the LINK button for 3
seconds to enable or disable the Video Link.
Channel Setup
Use the dropdown to select the broadcast reception channel for the
Receiver. The Receiver will display the video stream from the Transmitter
using the selected broadcast channel. The available channel range is from
0 to 255.
IP Setup
This section allows for configuration of the IP acquisition mode and
Ethernet settings of the unit. It also provides an easy way to find the
physical unit when installed with many other similar units.
-
IP Mode & Settings:
The IP mode may be switched between “Auto
IP”, “DHCP” or “Static IP”. When the unit is set to Auto IP mode it will