10
a
C:
Press this button momentarily to increase the streaming
channel to the next available channel on the local network.
Note: If no other channels are detected, the channel number will not
change.
b
Video Link:
Press and hold the button for 3 seconds to enable or
disable the Video Link. When the link is disabled and the Receiver
is connected to a display it will show the system’s current IP and
firmware information.
c
Reset to Factory Defaults:
Press and hold this button when powering
the unit on until both the POWER and LINK lights are blinking. Once
both lights are blinking you can reboot the unit and all settings will
be returned to the factory defaults (Including resetting the IP mode to
auto, broadcast channel to 0, and the streaming mode to multicast). A
new IP address will be assigned automatically within the 169.254.xxx.
xxx address range.
8
CH−/USB:
This button controls multiple functions:
a
Channel −:
Press this button momentarily to decrease the streaming
channel to the previous available channel on the local network.
Note: If no other channels are detected, the channel number will not
change.
b
USB:
Press and hold the button for 3 seconds to enable/disable the
USB connection between the Transmitter and the Receiver. (Multicast
Mode ONLY)
Note: In Multicast mode is it only possible to provide USB support to a
single Receiver at a time. Enabling USB on one Receiver will disable it on
all other Multicast Receivers on the same channel.
9
IR WINDOW:
Accepts IR signals from any standard remote control and
sends the signal to the IR Out on the associated Transmitter.
10
IR IN:
Connect to the provided IR Extender to extend the IR control
range of remotely located devices. Ensure that the remote being used
is within direct line-of-sight of the IR Extender.
11
IR OUT:
Connect to the provided IR Blaster to transmit IR signals from
the associated Transmitter to devices within direct line-of-sight of the
IR Blaster.
12
ISP SEL:
For factory use only.
13
RS-232 OUT:
Connect directly to an RS-232 controllable device to
receive commands from the device connected to the Transmitter. The