CYP IP-6000RX, Operation Manual, Page: 10 / 28

6 6
6.2 Receiver
RS232 LINK PAIR
SEL
IR IR
BLASTER
POWER
LINK USB 1.1 USB 2.0
MODE LINK
VIDEO
ON
1 2 3 4
1 2 3 4 5 6 7 8 9
1 POWER LED: Connects with 5V power, the power indicator will
fl ash in blue once power on and illuminate constantly in blue after
power on the unit.
2 LINK LED:
a. When Transmitter disconnects with Receiver or power on, the
orange LED indicator will not illuminate.
b. When Transmitter connects with Receiver and get link without
source connection, the LINK LED indicator will fl ash in orange.
c. When Transmitter connects with Receiver and get source
connection, the indicator will illuminate constantly in orange.
3 RS232: This slot connects with D-Sub 9-pin female null modern
cable from PC’s system, the RS-232 command will pass through
from Transmitter to Receiver or Receiver to Transmitter. The default
baud rate is setting at 115200. For multicast scenario, every single
Receiver unit can pass through RS-232 command to Transmitter.
Further, Transmitter is able to pass through RS-232 to all Receivers
on same channel.
4 IR Blaster: Connects with IR Blaster supplied in the package for IR
signal received from Transmitter side to blast out and to control the
desire device. For multicast scenario, the IR signal is able to pass
through to all Receivers on same channel.
5 IR: This IR window is for receiving the remote control signal and
sending it to Transmitter side for IR signal blast out.
6 LINK PAIR SEL: This dip switch allows user with matrix setting for
link up to 16 pairs of the devices with single IP router. Each pair
must have the same dip switch setting in order to pair to the right
device setting. The factory default setting is at 0000. Please reboot
the Transmitter & Receiver after selecting.
7 Video LINK: Presses button to disable and enable the link status.