CYP CPRO-U2T, Operation Manual

Page: 7 / 16

2
5. FEATURES
• HDMI 2.0 and DVI 1.0 compliant
• HDCP 1.4 compliant
• 1 HDMI input and 2 HDMI outputs
•
Supports HD resolutions up to 4096×2160@60Hz (4:2:0, 8-bit)
• Simultaneous display of a single 4K source on up to two 4K displays
• 3D signal support (with 3D source and compatible 3D TV)
• Supports pass-through of audio formats including LPCM 2.0/5.1/7.1,
Bitstream, and HD Bitstream
• System Reset function (CEC active source command)
• EDID management control including “Standard” (Internal EDID)
mode and “TV” (External Display EDID) modes
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
POWER IN
1 2
OUT
EDID SYS-RST
ON OFF
SERVICE
STD TV
1 2 3 4 5 6
1 POWER LED: This LED will illuminate to indicate the unit is on and
receiving power.
2
IN LED: This LED will illuminate to indicate that a live source has
been detected on the input port. When no source is detected the
LED will remain off.
3
OUT LEDs 1~2: These LEDs will illuminate to indicate when a valid
sink has been detected on the associated output port. When no
sink is detected the LED will remain off.
4
EDID SWITCH: This switch controls the EDID management behavior
of the unit. When set to “TV” mode the unit will read and store
the EDID from the sink connected to output 1 and pass it to the
connected source. When set to “STD” mode the unit will use a built
in EDID defined as 1080p@60Hz, 8-bit, LPCM 2.0.