CYP CPHD-V4, Operation Manual

Page: 42 / 120

37
Note: After the update process has been initiated, whether successful or
not, the unit will automatically reboot.
2) Image 640×480 Update: Provides a way to upload a custom image
to replace the default 640×480 variation of the “Image” pattern. After
selecting “Yes”, follow the on-screen prompt and insert a FAT32
formatted USB stick, with a valid image file (RGB, 24-bit, bitmap, named
IMG_480.BMP) in the root directory, into the unit’s USB service port. The
file copy process will begin automatically.
Note: After the file copy process has been initiated, whether successful
or not, the unit will automatically reboot.
3) Image 1920×1080 Update: Provides a way to upload a custom image
to replace the default 1920×1080 variation of the “Image” pattern.
After selecting “Yes”, follow the on-screen prompt and insert a FAT32
formatted USB stick, with a valid image file (RGB, 24-bit, bitmap, named
IMG_1080.BMP) in the root directory, into the unit’s USB service port.
The file copy process will begin automatically.
Note: After the file copy process has been initiated, whether successful
or not, the unit will automatically reboot.
4) [Colorbar] with border: Enable or disable a pair of grey border lines
around the unit’s color bar patterns (P13~P18).
5) [Letter H] Option 2: Set the font size of the Letter H (P37) pattern’s
second display variation.
6) 3D Source Image Bypass: Enable or disable showing a 3D source’s full
video content in scaled output mode. When enabled, both the left and
right eye content will be shown simultaneously with the signal’s native
orientation and spacing. When disabled, only the left eye’s view will be
output.
Note: Top-Bottom and Side-by-Side 3D only, frame-packed sources are
not supported.
7) Information Refresh: Set the frequency with which the information
displayed on analysis monitoring pages is refreshed.
8) IR Controller Address: Assign an address number (from 0 to 3) that
matches the setting on the remote that is to be used with the unit.
Note: The standard remote’s default factory setting is 0.
9) OLED Screen Saving: Enable or disable the OLED display’s
screensaver function.
10) Copied EDID Reset: Selecting “Yes” will clear all of the unit’s Copied
EDIDs.