4
6.2 Rear Panel
LAN
ANALOG OUT
HDMI OUT
CAT 5e/6/7 IN
IR IN
IR OUT
SERVICE
DC 24V
ON
OFF
TXRX
BYPASS
L
R
RS-232
1
2
3
4
5
6
7
8
1
DC 24V Port:
Plug the 24V DC power adapter into this port and
connect it to an AC wall outlet for power.
2
SERVICE Switch:
This switch is reserved for factory use only. The
default setting is “OFF”.
3
BYPASS RS-232 Terminal Block:
Connect to a PC, laptop, or serial
controllable device with a 3-pin adapter cable for the extension of
RS-232 signals between both ends of the HDBaseT connection.
4
IR OUT Port:
Connect to the provided IR Blaster to transmit IR signals
from the other end of the HDBaseT connection to devices within
direct line-of-sight of the IR Blaster.
IR IN Port:
Connect to the provided IR Extender to receive IR
control signals and extend them to devices connected to the
other end of the HDBaseT connection. Ensure that the remote
being used is within direct line-of-sight of the IR Extender.
5
CAT 5e/6/7 IN Port:
Connect to a compatible HDBaseT Transmitter
with a single Cat.5e/6/7 cable for reception of all data signals. PoH
will also be supplied to a connected compatible PD Transmitter.
6
ANALOG OUT Terminal Block:
Connect to powered speakers or an
amplifier for balanced analog stereo audio output. This will output
the independent audio channel sent by compatible HDBaseT
Transmitters.
7
LAN Port:
Connect to an Ethernet supporting device or to your
local network, as appropriate, to extend the network to both ends
of the HDBaseT connection.
8
LAN Port:
Connect to an Ethernet supporting device or to your
local network, as appropriate, to extend the network to both ends
of the HDBaseT connection.
