5
6.3 EDID Learning Procedure
To Read the EDID:
1. Connect a TV/display to the HDMI output for EDID reading.
2.
Set the 'Emulator/Bypass (2)' switch to 'Emulator' first then set the
'Rd/Wr (1)' switch to the 'Rd. (Read)' position.
3. Press the 'Select' button for 3 seconds to put the unit into 'Learned'
mode.
4. Press the 'Select' button repeatedly to cycle through to the
required 1 to 8 EDID setting.
5. Press the 'SET' button for 3 seconds to write the EDID to the
corresponding memory as indicated by the LED.
6.
When the 'STATUS' LED illuminates in Green the EDID learning has
been successfull but if the 'STATUS' LED is Red the learning has
failed.
To Write the EDID:
1. Connect a TV/display to the HDMI output for EDID writing.
2.
Set the 'Emulator/Bypass (2)' switch to 'Emulator' first then set the
'Rd/Wr (1)' switch to the 'Wr. (Write)' position.
3. Press the 'Select' button repeatedly to cycle through to the
required 'Learned/Default' 1 to 8 EDID setting.
4. Press the 'SET' button for 3 seconds to overwrite the HDMI TV/
display EDID setting. The 'STATUS' LED will blink during the writing
process.
5.
When the 'STATUS' LED illuminates in Green the EDID writing has
been successful but if the Status LED is Red the writing has failed.
If the 'STATUS' LED did not blink and illuminate in Red it means TV's
EDID is not writable.
Warming: Once the writing is successfully done the original EDID
will be erased. It is recommended that the original EDID settings are
backed-up by storing them in the unit before performing the overwrite.
Caution is advised when using this function.
