Automotive HD Video Recorder
Automotive HD Video Recorder
4
7
PARTS IDENTIFICATION
5
4
9
11
# DESCRIPTION
IMPORTANT:
While pressing the position adjustment button, insert the recorder into the bracket,
aligning the mini USB power source in the bracket with the mini USB power slot in the recorder
1. Press & Hold Position
Adjustment Button
2. Insert the Recorder
Into the Bracket
2
1
Set Screw
Located
Behind Here
10
12
8
1. Driver Event Button
7. Status LED’S (PWR, GPS, Wi-Fi)
2. Photo Button
8. Mounting Bracket
3. Micro SD Card Slot
9. Mounting Bracket With Cable
4. Reset Button
10. Position Adjustment Button
5. Mini USB Power Slot
11. Power Cable Module
6. Microphone
12. Mounting Surface With Tape
6
# DESCRIPTION
3
WIRING
Electrical systems vary from vehicle to vehicle. Please refer to your vehicle’s manual for details
prior to installing a CYL-V recorder.
This is the preferred installation of CYL-V instruction for commercial and other fleet vehicles.
The CYL-V Power Cable includes important voltage regulation and safety circuits which are
necessary for proper operation of CYL-V Recorder. NEVER use power cables other than those
supplied with CYL-V. Make sure ignition is off during installation.
EXAMPLE:
Ground Wire
connected to the
vehicle chassis ground
1. Prepare all the parts necessary for installation.
2. Find the location of the fuse box in the vehicle. Identify
the fuses for connection of the RED POWER wire and
the YELLOW IGNITION. Identify appropriate location
for installation of the Power Module in the vehicle.
3. After determining that Power Module location is
appropriate, make the following connections:
a. Connect the BLACK WIRE (GROUND -) to chassis
ground.
b. Connect the RED WIRE (POWER +) to a constant
– powered. Source which will remain live after the
ignition is turned OFF.
c. Connect the YELLOW wire (IGNITION) to an ACC
power source. (NOTE: it is very important to select
a connection point which has zero voltage when
the vehicle ignition turns to OFF. See further details
on next page.)
4. Identify approximate CYL-V Recorder location
on windshield. Confirm sufficient cable length available
to reach from windshield location to the under-dash
connection to Power Module. Remove the A-Pillar
cover and route the cable as needed.
5. Connect the Power Module to Power Cable.
5