5
ASSEMBLY
6
1.
Time of charging for the first time:
7 hours.
2.
Time of any subsequent charging:
about 4 hours.
3.
To keep the scooter in good performance, you need to charge it at least once a month when it is
not
regularly used.
ASSEMBLING THE STEERING HANDLE
Tools needed: 2 pcs 4mm
hex keys
CHARGING THE BATTERY
The scooter must always be switched off while being charged
.
Your electric
scooter
must be charged for
7 hours prior to the first use.
Do not use the scooter for the first time unless you have charged the battery
for 7 hours! Failing to follow these instructions may harm your scooter performance and void the warranty.
Attention:
An indicator on the charger shows the status of charging. The charger heats up during
charging. This is normal and is no cause for concern.
Attention:
The battery must be charged at least once a month when the scooter is not in regular use.
Otherwise, the charging performance of the battery may degrade.
USING THE SCOOTER
USING AS A KICK SCOOTER
Hold the handlebar with both hands and place one foot on the deck.
Using your other foot, kick yourself along by pushing your feet along the ground.
To turn, rotate the handlebar
s
left or right to go the desired direction.
To slow down, gently push down on the rear brake.
To stop, push the rear brake all the way.
According to the figure 1, align the steering T-bar and push it onto the
fork tube. Ensure
all
four holes
are aligned
with each other.
(The th
rottle
knob on the handle shall be on the right
hand
side when
installed.)
Check that the power switch is in the “OFF” position before plugging in
your charger. Plug the charger
cord
into the charging socket, which is
on the
right side of the battery box.
Plug the charger into the mains outlet and turn on.
The charger indicator
will
come
on.
A re
d color indicates that the battery is being charged, and
a
green color indicates that the battery is full
y charged
.
Insert a hexagon round flat head nut and bolt into the lock hole, as indicated
in the drawing, and tighten them using two 4mm
hex keys
ON
OFF
USING AS AN ELECTRIC SCOOTER
Ensure the power switch is on the ‘ON’ position. The switch is located
on the right side of the deck.
Put one foot onto the deck and place both hands onto the handlebar.
To accelerate, press the throttle
knob
next to the right handlebar grip.
The further you push, the faster the scooter will go.
Make sure that both feet are on the scooter deck while riding.
To turn, rotate the handlebar
s
left or right to go the desired direction.
To
slow down, release the throttle
knob
and push down on the rear brake
with your foot.
Once you have finished using your scooter, please turn the power
switch to the ‘OFF’ position.
