11
Cyclone Canopy Installation - English
3. Position the ceiling mounting plate in such a way that one of
the sides with three screw holes faces the front of the hood.
Secure mounting bracket to the ceiling using four wood
screws. Ensure that screws are driven into the center of the
framing for maximum strength. Assemble two upper side
brackets to the ceiling mounting bracket using six mounting
screws (three per bracket) (Figure 5 & 6).
4. Use eight screws to mount the lower brackets to the upper
brackets. Determine lower brackets mounting height based
upon installation height D of the mounting bracket.
Mounting Bracket
Install the Island Hood
1. Remove the filters from the hood; attach the adapter/damper
to the top of the hood.
2. Measure the required length of 6” round metal duct from the
adapter/damper to the ductwork rough-in in the ceiling.
Connect this section of duct to the adapter/damper and seal
joint with metal foil duct tape.
Mounting Screws
3. Slide the lower and upper chimney flues
over the installed mounting bracket
and have a second person hold it to the
ceiling.
4. Attach the hood to mounting bracket using
six screws (three per side) (Figure 7).
5. Slide the lower and upper chimney flues
down on top of the hood. Install the
electrical connection and connect the
duct to the rough-in duct work in the
ceiling. Seal the joints with metal foil
duct tape.
6. Power up hood and check for leaks
around duct tape.
7. Carefully slide the upper (inner) flue
over up to the ceiling and secure it to the
mounting plate from both sides.
8. Reinstall filters to the hood, peel off the
protective plastic film covering the flues
and the hood.
Note: For some models, the “L” shape support frame may be
used (Figure 8). The installation procedures are same except
that the hood is mounted on one side. If need be, use an
adjustable string wire from other side to keep the hood level.
Figure 6.
Figure 7.
Figure 8.
Note: 10 Feet Ceilings
For SI520, use the mounting brackets and duct covers supplied.
For any other models, optional extension mounting brackets
and duct covers need to be ordered.
