TROUBLESHOOTING CONTINUED
7)
You want to override your Liberator product so you can fix, wash, or trailer your
motorcycle:
Use your override PIN number (standard setting for each Liberator unit is
1234) to send an override command. This command is sent as a Text message from your
cellular phone and requires a 4 digit PIN number that only you should know. When
sending the Text message, the Liberator
must
be in normal power mode (please see # 6
above to get system into normal power mode).
IMPORTANT NOTE
:
To change your PIN, go to
www.cycleprotect.net
, login, and then
press the change configurations button. Follow the instructions for item #3 on that page.
Once this override command is received, the alarm system will be disabled until you re-
enable your alarm. This can be accomplished by simply sending an override cancel
command or by starting your motorcycle engine for approximately 60 seconds.
PLEASE NOTE:
The override commands are sent from your cell phone as a Text
Message to your serial number of your Liberator unit (
Example:
, and have the following format:
*
!11
**** to override the alarm system, where **** is your PIN Number (example
!111234
to override)
*
!00
**** to cancel the override, where **** is your PIN Number (example:
!001234
to
cancel override)
Important:
Manual Override turns off
all
of the Liberator features, so make sure you re-
enable your alarm by sending an override cancel command or by starting your
motorcycle engine and letting it run for approximately 60 seconds. Make sure you check
the GPS site History page to see if the function was performed.
Page 6
