03
INSTALLATION
Installation of 68/73/83mm version
Line up the motor body with your bike at the bottom bracket.
For a 68mm bottom bracket width, place the 3mm spacer
between the mounting brackets & the bottom bracket shell as
needed & shown on previous page. For 73mm & 83mm bottom
bracket widths, no spacer is needed.
01.
Thread in the right (drive side) bottom bracket cup through the
hole on the right mounting plate & into the bike’s bottom
bracket shell. Note the thread direction is anti-clockwise.
02.
Thread in the left (non-drive side) bottom bracket cup through
the hole on the left mounting plate (and spacers for 68mm &
73mm bottom bracket widths) into the bike’s bottom bracket
shell. Note the thread direction is clockwise.
03.
Insert the spindle from the right (drive-side) side of the rear
mounting bracket hole through to the left side of the rear
mounting bracket hole.
04.
01.
02.
03.
04.
Screw on the left (non-drive side) bottom bracket cap.
05.
05.
Kindly note that there are installation videos available at
https://www.cycmotor.com/x1-stealth
