CYBEX VR1 Lat/Row, Owner'S And Service Manual

Page: 24 / 40

Cybex VR1 Owner’s Manual
Maintenance
Page 5-2
More Diffi cult Stains
Dampen a soft white cloth with a solution of 10% household bleach (sodium hypochlorite),
•
90% water. Rub gently. Rinse with a water dampened cloth to remove bleach concentration.
The same procedure can be used with full strength household bleach, if necessary.
•
Allow bleach to puddle on the affected area or apply with a soaked cloth for approximately
•
30 minutes. Rinse with a water dampened cloth to remove any remaining bleach concentration.
Alternative Method for Diffi cult Stains
Dampen a soft white cloth with rubbing alcohol and rub gently. Rinse with a water dampened cloth
•
to remove any remaining rubbing alcohol concentration.
NOTE: To restore luster, a light coat of spray furniture wax can be used. Apply for 30 seconds and
follow with a light buffi ng using a clean white cloth.
Please Review Carefully
When using strong cleaning agents such as rubbing alcohol or bleach, it is advisable to fi rst test in an
inconspicuous area. Other cleaning agents may contain harsh or unknown solvents and are subject to
formula changes by the product manufacturer without notice. Should you desire to use other
cleaning agents, carefully try them in an inconspicuous area to determine potential damage to the
material. Never use harsh solvents or cleaners which are intended for industrial applications. To clean
stained or soiled areas, a soft white cloth is recommended. Avoid use of paper towels.
Cleaning products may be harmful/irritating to your skin, eyes, etc. Use protective gloves and eye
protection. Do not inhale or swallow any cleaning product. Protect surrounding area/clothing from
exposure. Use in well ventilated area. Follow all product manufacturer’s warnings. CYBEX and its
vendors cannot be held responsible for damage or injuries resulting from the use or misuse of cleaning
products.
2. Frames - Wipe down all frames using a mild solution of warm water and car wash soap. Be sure
to dry thoroughly. AVOID acid or chlorine based cleaners and also cleaners containing abrasives as
these could scratch or damage the equipment.
3. Chrome - Clean chrome tubes, fi rst using chrome polish and then using a car wax seal. Neutral
cleaners with a pH between 5.5 and 8.5 are recommended. Be sure to dry thoroughly. AVOID acid or
chlorine based cleaners and also cleaners containing abrasives as these could scratch or damage the
equipment.