CYBEX Eagle 11181, Owner'S Manual

Page: 18 / 32

Cybex Eagle 11181 Hip Abduction/Adduction Owner’s Manual
Assembly
Page 4-2
Disconnect weight stack belt (by loosening the two set B.
screws on the belt clamp with a 7/32” Allen wrench).
See Figure 1.
With an assistant, carefully remove the four BHSCS C.
securing the two halves of the frame. See Figure 2.
Carefully move each half through the door-way to the D.
desired location.
With an assistant, carefully attach each half together E.
using the four BHSCS removed in step 4C. See Figure 2.
Continue on with step 5B. F.
5. Remove shipping feet and remove the back shrouds.
Carefully remove each (standard) cone-shaped A.
shipping support) using a 3/4” socket or wrench).
Carefully place rubber feet (supplied with machine) B.
on each foot of the frame.
Cut shipping tie securing top weight. C.
Lift top weight and turn the Increment Weight Adjusting D.
Knob to select all 15 lbs. (three increment weights each
side).
Remove the three Phillips head screws securing the E.
top (back) shroud and carefully remove the shroud.
See Figure 3.
Loosen bottom two screws shown in Figure 4. F.
NOTE: Do not remove the bottom two screws.
Remove the top two screws securing the back G.
shroud. See Figure 5.
Carefully slide rear shroud assembly upward and H.
remove.
6. Install the weight stack.
Note how the increment weights are installed. A.
With an assistant holding the increment weights, move B.
the adjusting knob to 0 lbs. and remove all six increment
weights (three each side).
Figure 2
Figure 5
Figure 3
Figure 4
BHSCS (qty 2)
Nylon Locknut (2)
BHSCS (qty 2)
Nylon Locknut (2)
Phillips Head
Screw (3)
Screw (loosen -
do not remove)
Screw
Figure 1
set screws (2)