Cybex Eagle 11111 Fly/Rear Delt Owner’s Manual
Assembly
Page 4-2
With an assistant, carefully remove the six Button Head
C.
Socket Cap Screws (BHSCS) securing the two halves of
the frame. See Figure 2.
Carefully move each half through the door-way to the
D.
desired location.
With an assistant, carefully attach each half together
E.
using the six BHSCS removed in step 4B. See Figure 2.
Route the weight stack belt (removed in step 4B)
F.
and secure it to the clamp using the two set screws.
See Figures 8A and 8B.
Continue on with step 5B.
G.
5.
Remove shipping feet and remove the back shrouds.
Carefully remove each (standard) cone-shaped
A.
shipping support (using a 3/4” socket or wrench).
Carefully place rubber feet (supplied with machine)
B.
on each foot of the frame.
Cut shipping tie securing top weight.
C.
Lift top weight and turn the Increment Weight Adjusting
D.
Knob to select all 15 lbs. (three increment weights each
side).
Remove the three Phillips head screws securing the
E.
top (back) shroud and carefully remove the shroud.
See Figure 3.
Loosen bottom two screws shown in Figure 4.
F.
NOTE: Do not remove the bottom two screws.
Remove the top two screws securing the back shroud
G.
assembly. See Figure 5.
Carefully slide rear shroud assembly upward and remove.
H.
Loosen set screws and remove belt from the top weight.
I.
Pull belt out of the top shroud.
J.
Remove the three Phillips head screws securing the top
K.
(front) shroud on the front side and carefully remove the
shroud.
6. Install the weight stack.
Note how the increment weights are installed.
A.
With an assistant holding the increment weights, move
B.
the adjusting knob to 0 lbs. and remove all six increment
weights (three each side).
Figure 2
BHSCS (2)
Locknut (4)
BHSCS (2)
Locknut (2)
BHSCS (2)
Figure 3
Phillips Head
Screw (3)
Figure 4
Screw
Figure 5
Screw
Summary of Contents for Eagle 11111
