Cybex Sport+ Treadmill Owner’s and Service Manual
! WARNING: All maintenance activities shall be performed by qualified personnel.
Failure to do so could result in serious injury.
For any service related concerns, call Cybex
Customer Service at 800-766-3211 (for Cybex
customers living within the USA). For
customers living outside the USA, call 508-
533-4300 or fax 508-533-5183.
NOTE:
Read and understand each procedure
thoroughly before servicing. Unless otherwise
noted “right” and “left” denote user orientation
for all procedures.
Test Mode
To enter
Test Mode
press and hold down any key on the display while turning the power
switch to the on (I) position. When all keys are released the software revision “rx.x” is shown
on the display. The display automatically scrolls through the following data for three seconds
each:
rev
, (revision)
unit
(unit of measurement),
line
(frequency),
dist
(distance or total miles),
hour
(total hours),
strt
(number of starts),
log
(error codes 1-5). Afterward “TEST” appears on the
display. To exit
Test Mode
press
Stop
.
Stuck Key List
If
Test Mode
occurs without holding any keys, a key may be stuck closed or Error 7 may have
occurred. If “btn” (button) and a number is displayed you can determine which key is stuck
closed by referring to the list below. If a key is stuck closed you may need to replace the lower
display overlay. See Figure 1. Follow the
Display Overlay
procedure located in this chapter.
btn1
Stop
btn2
Incline Down
btn3
Speed -
btn4
Pace
btn7
Weight
btn8
Scan
btn9
Incline Up
btn10
Speed +
btn11
Quick Start
btn12
Cal
btn13
Level
btn15
Enter
btn16
Weight Loss
btn17
Dist
btn18
Adjust Down
btn20
Heart Rate
btn21
Manual
btn22
Mets
btn25
Adjust Up
btn26
Cardio
Figure 1
Upper
Overlay
Lower
Overlay
Service
Page 7-2
