CyberResearch CYRAQ PPC Series, User Manual

Page: 42 / 103

C
Y
RAQ
®
PPC Series CyberResearch
®
Panel PCs
30
©Copyright 2006
CyberResearch, Inc.
5. Connect one end of the IDE ribbon
cable to the IDE interface at the back
of the optical drive. Match the red
stripe on the cable with Pin 1 on the
IDE interface.
6. Connect one end of the optical drive
audio cable to the 4-pin connector at
the back of the optical drive.
7. Connect the other end of the IDE
ribbon cable to the 57 connector on
the motherboard. See page 57 for the
location of the PRI_SIDE connector.
8. Connect the other end of the audio
cable to the 4-pin CD connector on the motherboard. See page 59 for the location
of the CD connector.
9. Re-install the storage drive assembly, then secure it with the screws you earlier
removed. IDE cable
Replacing or Upgrading A Pre-Installed Optical Drive
In the future, you may need to replace a defective optical drive or upgrade an installed
one:
1. Make sure the optical drive you intend to install complies with the recommended
dimensions mentioned in
page 28.
2. Lay the storage drive
assembly on its top on a flat
surface.
3. Remove the screws of the
optical drive you intend to
replace. Keep the screws for
later use.
4. Remove the old optical
drive, then set aside.
5. Insert the new optical drive
to the bay.
6. Follow steps 3-9 of the previous section to complete installation.