CyberOptics SE500ULTRA, Hardware Manual

Page: 103 / 188

CyberOptics Corporation 93
Conveyor Components
Conveyor Components
This section contains procedures for replacing the following conveyor components:
●
Conveyor clamp blade
●
Conveyor clamp air fittings
●
Conveyor clamp hall effect switch
●
Conveyor clamp cylinder
●
Conveyor motors
●
Tension pulleys and conveyor belts
●
Board sensors
●
Panel lifter inductive sensor
●
Panel lifter cylinder
Replacing the Conveyor Edge Strip Guides
The conveyor has one edge guide on the front rail and one on the rear rail. Check these strips for
wear and replace as necessary.
Parts
Top Cap Extrusion
Required Tools
–
No. 3 Allen Key
– Mallet
– Driving Tool
–
Wrench size 7 mm
– Threadlocking sealant
– Long Nose pliers
➢
To replace the conveyor edge guide
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 52
.
2. Open the hood.
Caution:
Turn the AC main circuit breaker to OFF to shut down all electrical power to the
SE500
ULTRA
unit before replacing any parts or components. For more information, refer to the
section “ Shutting Down the System ” on page 52.
Warning: Make sure the AC main circuit breaker is turned OFF and power is disconnected
from the mains before working inside the hood. Gantry motion can pinch or sever objects in its
path.
i
Note: For Parts Replacement, contact CyberOptics for part numbers.
i
Note: For this replacement procedure, the machine is not accessible at the left/right. The
machine needs to be removed from the production line. This section shows the procedure
performed when the machine is not in production line.
Caution:
Be careful not to nick or scratch the rail.