FlashLock Padlock Battery
Replacement Instructions
Figure 5:
Gap between Cap and Padlock
Figure 6:
Proper Cap Installation with no Gap
between Cap and Padlock
Note: The circuit board should beep when it makes
contact with the battery. If it does not, check that
the battery is new and inserted correctly.
13) Gently replace the cap over the circuit board and screw
it on until the cap locks in place for the first time with
an audible click.
14) Reinsert the pin as in Step 5 and rotate the cap
clockwise approximately 10 degrees but
no more
.
15) Remove the pin and continue screwing on the cap until
it locks in place a second time. There should be
no
gap
between the cap and the padlock body. See Figure
5 for reference of visible gap.
16) Verify that the cap is locked in place by the internal
latch and can’t be unscrewed. The Allen wrench should
be aligned with the center of the home mark. Note
Figure 6 for proper cap installation without a gap
between the cap and padlock body.
17) Remove the Allen wrench and check the padlock for
functionality.
For further questions and assistance, please contact
CyberLock Support by email at [email protected]
or by calling 541-738-5500
MN-FLK-04 GCO4526
Aligned
