CyberData Singlewire InformaCast Series, Operation Manual, Page: 62 / 91

Installing the Singlewire InformaCast® RGB (Multi-Color) Strobe
Singlewire InformaCast® RGB (Multi-Color) Strobe Setup
Operations Guide 931633A CyberData Corporation
54
2. On the Events page, enter values for the parameters indicated in Table 2-16 .
Note The question mark icon ( ) in the following table shows which web page items will be defined
after the Toggle Help button is pressed
.
Table 2-16. Events Configuration Parameters
Web Page Item Description
Enable Event Generation The device will send HTTP POST events to the specified remote server and port
number whenever a certain action takes place. Select an event type below to
generate an HTTP POST event.
Events
Enable Relay Activated Events When selected, the device will report relay activation.
Enable Relay Deactivated Events When selected, the device will report relay deactivation.
Enable Ring Events When selected, the device will report when it starts ringing upon an incoming SIP
call.
Enable Night Ring Events When selected, the device will report when it starts ringing upon an incoming SIP
call to the Nightringer extension. As a reminder, the Nightringer extension always
rings upon an incoming SIP call and it is not possible to alter this behavior.
Enable Multicast Start Events When selected, the device will report when the device starts a strobe scene when
the device receives a multicast.
Enable Multicast Stop Events When selected, the device will report when the device stops a strobe scene when
the multicast stream ends.
Enable Power On Events When selected, the device will report when it boots.
Enable Sensor Events When selected, the device will report when the on-board sensor is activated.
Enable 60 Second Heartbeat Events When enabled, the device will report a Heartbeat event every 60 seconds. SIP
registration is not required to generate Heartbeat events.
Enable Informacast Start Events When selected, the device will report when a Start event has been received from
the Singlewire server.
Enable Informacast Stop Events When selected, the device will report when a Stop event has been received from
the Singlewire server.
Check All Click on Check All to select all of the events on the page.
Uncheck All Click on Uncheck All to de-select all of the events on the page.
Event Server
Server IP Address The IPv4 address of the event server in dotted decimal notation.
Server Port Specify the event server port number. The supported range is 0-65536. Enter up to
5 digits.
Server URL Generally, the destination URL is the name of the application that receives the
events and the string in the HTTP POST command. It can be a script used to parse
and process the HTTP POST events. Enter up to 127 characters.
Click the Save button to save your configuration settings.
Click on the Reboot button to reboot the system.