C.A.R.E 2000
Maintaining Your C.A.R.E. 2000
CLEANING AND CHANGING FILTERS
HOW TO CHANGE THE POST FILTER
NOTE:
WHEN CHANGING THE UV BULBS IT IS RECOMMENDED TO REPLACE THE
POST FILTER UNDER THE OUT FLOW VENTS WHEN THE ACCESS PANEL
IS OPEN.
HOW TO CHANGE THE ULTRAVIOLET LAMPS
TOOLS REQUIRED:
A phillips screw driver
A cloth or glove (for New Ultraviolet Bulbs)
SAFETY WARNINGS
UNPLUG UNIT BEFORE SERVICING.
NEVER LOOK DIRECTLY INTO THE ULTRAVIOLET LAMPS WHEN LIT.
1. Open top access panel,
FIG.7
Remove the 4 corner screws,
carefully lift access panel and gently hang
off side.
BE CAREFUL NOT TO DISCON
NECT WIRES.
2. Lift shield plate slightly
FIG 8
. vertically and
slide forward from middle support bar.
3. Carefully cut the black nylon shipping tie
from around the base of each Ultraviolet
lamp.
BE CAREFUL NOT TO CUT THE
WHITE LAMP WIRE
.
FIG.9
While holding
the lamp socket with one hand, gently pull
the lamp straight out from its socket.
4. Discard the old lamps, place them in a trash
bag and throw them away.
5.
DO NOT TOUCH
the glass of the New
Ultraviolet lamps with your hands, as the oil
on your skin may alter the performance of
the lamps. Use a cloth or gloves.
6. Reinstall the HEPA + carbon drum with
the pre-filter around it. Push all the way
back into the inner chamber. The seam of
the pre-filter should face you.
7. Replace rear access panel and only
replace the (2) screws at the bottom of
access panel.
8. Line up top access panel with 4 holes and
replace screws with phillips screwdriver.
STAND UNIT UPRIGHT
AND PLUG INTO WALL OUTLET,
TURN UNIT TO DESIRED SPEED.
1. Peal off Post Filter
2. Place new post filter onto existing
velcro strips
6
FIG.7
FIG.8
FIG.9
