17.
Attach other end of flex hose to intake
of unit using hose clamp provided.
18.
Place unit into cabinet, screw bottom
into predrilled holes using ½’’ screws
provided. Level top unit and screw
into side wall of cabinet using ¾’’
screws provided.
19.
Plug into a 120 volt electrical receptacle
and unit is ready for use.
16.
Slide vacpan into mounting slot with
vacpan trim plate.
Note:
Installation Without Faceplate
On the toe kick of the cabinet, mark and cut
out a 6 3/4” x 1/34” high slot.
The vacpan can be installed in the toe kick of
the cabinet without using the trim plate, by
gaining access through the cabinet floor. Cut
a 2 ¾’’ x 3 ½’’ access hole 6’’ from the face
of the cabinet to the front edge of the access
hole.
Connect the low voltage wire through the slot
in the toe kick, up through the hole drilled in
step #10.
Use the access hole to feed the wire. Screw
the vacpan into place. Connect the flex hose
to the 90 degree spigot adapter and fasten
with hose clamp. Feed attached elbow and
flex hose through hole drilled in step #10 to
the front of the cabinet. Through the access
hole, attach 90 degree Spigot Adapter to
vacpan.
Attach other end of flex hose to the intake of
unit, and attach low voltage wires at unit,
and anchor unit as described in steps #17
and #18. Plug into a 120 volt electrical
receptacle and unit is ready for use.
Access Hole
Then screw to toe kick with # 6 screws
provided.
6
