CUTTERS EDGE
770
/970/12
7
0 Model
Starting & Stopping
CE12
7
0 RH
English
– 17
Before starting
•
Perform daily maintenance. See instructions in the section
"Maintenance".
Starting
•
Decompression valve:
Press in the valve to reduce the
pressure in the cylinder, this is to assist starting the power cutter.
The decompression valve should always be used
when starting.
The valve automatically returns to its initial
position when the
machine starts.
•
Choke - cold engine:
Pull the choke control fully out.
•
Start throttle position:
Press in the throttle trigger lock,
throttle
control and then the start throttle lock (A). Release the throttle
control and it is locked in the half throttle
position. The lock
releases when the throttle control is
pressed in fully.
Start the engine
•
Grip the front handle with your left hand. Put your right foot on the
lower section of the rear handle pressing the
machine against
the ground.
Never twist the starter
cord around your hand.
•
Grip the starter handle, slowly pull out the cord with your
right
hand until you feel some resistance (the starter pawls grip), now
quickly and powerfully pull the cord.
•
With a cold engine:
The machine stops when the engine
fires
becase the chokel control is pulled out.
Press the choke control and the decompression valve.
Pull the
starter handle until the engine starts.
•
When the engine starts, quickly apply full throttle to
automatically disengage fast idle.
!
WARNING! Please read the operator’s
manual carefully and make sure you
understand the instructions before using the
machine.
Wear personal protective equipment. See
instructions under the heading ”Personal
protective equipment”.
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
serious personal injury.
Check that the fuel cap is properly secured,
and that there is no fuel leakage. Risk of fire.
!
WARNING! The cutting blade rotates when
the engine is started. Make sure it can rotate
freely.
NOTICE! Do not pull the starter cord all the way out and do not let
go of the starter handle when the cord is fully extended. This can
damage the machine.
21
