16
ASSEMBLY (cont.)
CUTTERHEAD GUARD ASSEMBLY
1.
Attach cutterhead guard to the jointer by tightening the screw (A) SEE FIG. 8
The cutterhead guard has a tension return spring. The tension on this spring is set at the factory.
When the guard is installed properly it should return to the fence automatically after the work
piece has passed over the cutterhead. Be sure the guard is functioning properly every time before
using the jointer. If adjustment is necessary, remove the guard and while holding guard
attachment base, rotate guard counter-clockwise to increase tension. Then mount guard base
while holding guard and mounting base to prevent from losing tension.
DUST PORT ASSEMBLY
A dust port (A) is supplied with the jointer to help connect it to a standard 2-1/2 inch vacuum hose.
1. Tighten screws (B) by 4 mm hex wrench & screws (C) by phillips screwdriver when dust port (A)
is in proper location. SEE FIG. 9
NOTE: Do not attach thi
s dust port if you don’t plan to use a dust collector.
Summary of Contents for 40160H-CT
Page 30: ...30 PARTS...
Page 31: ...31...