Cutech 40160H-CT, User Manual, Page: 12 / 33

12
UNPACKING & INVENTORY
Check shipping carton and machine for damage before unpacking. Carefully remove packaging
materials, parts and machine from shipping carton. Always check for and remove protective
shipping materials around motors and moving parts. Lay out all parts on a clean work surface.
Remove any protective materials and coatings from all of the parts and the jointer. The protective
coatings can be removed by spraying WD-40 on them and wiping it off with a soft cloth. This may
need to be redone several times before all of the protective coatings are removed completely.
After cleaning, apply a good quality paste wax to any unpainted surfaces. Make sure to buff out
the wax before assembly.
Compare the items to inventory figures and verify that all items are accounted for before
discarding the shipping box.
NOTE: Some parts may already be installed on your machine. Go through the entire manual
before calling.
If any parts are missing, do not attempt to plug in the power cord and turn “ON” the machine. The
machine should only be turned “ON” after all the parts have been obtained and installed correctly.
For missing parts, contact CUTECH at
858-886-7333 .
A. Jointer H. Flat Washer O. Switch Key
B. Fence I. Tilt Lock Lever Assy. P. Torx Wrench
C. Cutterhead Guard J. Soc Button head Screw
D. Fence Sliding Bracket K. 2.5mm Hex Wrench
E. Fence Bracket L. 4mm Hex Wrench
F. Dust Port M. Special Nut
G. Push Blocks N. Knob