15
CustomControls, LLC
REGULAR MAINTENANCE
To keep the ValveSentry™ device in good working order:
•
Test it at least twice a year using the above procedure.
•
Vacuum the ValveSentry™ device cover once a month, using the soft brush attachment. Never use water, cleaners, or solvents, since
these may damage the unit. Test the ValveSentry™ device again after vacuuming.
•
Replace the batteries when the ValveSentry™ device “chirps” about every minute (the low battery warning). The low battery warning
should last for 30 days, but you should replace the battery immediately to continue your protection.
•
Replace the batteries once per year under all circumstances. Under certain battery failure modes, the battery will produce enough
voltage to fool the low battery test circuit so it does not chirp but that same battery will fail when it needs to provide high current to
power the motor.
•
Test the valve the ValveSentry™ device is attached to making certain it can be opened and closed completely. If the valve does not
work the ValveSentry™ device cannot operate correctly.
Choosing a replacement battery:
This ValveSentry™ Device requires
seven (7) standard AAA batteries
. These replacement batteries are commonly available at local retail stores.
WARNING: DO NOT ATTEMPT TO INSTALL 8 AAA BATTERIES – THIS WILL DAMAGE THE CONTROLLER.
WARNING:
Never use rechargeable batteries since they may not provide a constant charge.
CAUTION:
DO NOT spray cleaning chemicals or insect sprays directly on or near the ValveSentry™ device. DO NOT paint over the ValveSentry™
device. Doing so may cause permanent damage.
CAUTION:
Household cleaners, aerosol chemicals, and other contaminants can affect the sensor. When using any of these materials near the
ValveSentry™, make sure the room is well ventilated.