CC150MOB
General Production Hose Crimper
8
HYDRAULIC DIE INSTALLATION
Bring the crimper head to fully opened position as shown
in photo A.
Install the Hydraulic Dies with the quick change tool as
shown in photo B.
Note:
The die size stamped on the face of the die should
face toward the operator.
Note:
Consult your hose and fitting manufacturer’s spec
-
ifications for the correct die set for the hose and fitting
being crimped.
Align the studs of the Hydraulic Dies with the holes in the
Master Dies and SLOWLY close the crimper head on the
die set as shown in photo B.
Bring the crimper head to a fully closed position as shown
in photo C.
Remove the quick change tool as shown in photo D.
Note:
The dies may also be inserted manually with the
crimper head in the fully open position.
Proceed to the Crimping Instructions to set up the crimper
for the hose and fitting being crimped.
Note:
For Hydraulic Die Removal
, bring the crimper head
to the fully closed position as shown in photo D.
Insert the quick change tool and open the crimper head
releasing the Hydraulic Dies from their spring retention
holes as shown in photo E.
A
B
C
D
E
