PORTABLE MASSAGE TABLE USER’S GUIDE AND WARRANTY
5
Portable Massage Table
PORTABLE TABLE SET UP
To close your table:
1. Turn the table on its side, resting on the rubber bumpers.
2. Store the headrest and arm sling under the table.
3. Fold the legs into the table; make sure the cables are inside the table.
4. Make sure to fold cable in. (Picture 3 and 4)
5. Secure the latches and store in the carrying case.
PICTURE 1
PICTURE 2
PICTURE 3 - CORRECT
PICTURE 4 - INCORRECT
To use the Shiatsu cable:
1. Lay table upside down. Examine how the elastic string is positioned,
so you can correctly restore it to draw up the cables when closing
your table.
2. Locate the joint connector nut at the
junction of the long and short cable.
3. Press in the spring-loaded tab and slide the
end of the long cable off of the nut, leaving
the washer and -the short cable on the nut.
4. Remove one end only of both long cables.
5. Fold the legs against the table top and tuck the cables down so they do
not bind against the table top or the floor. Lay the table flat on the floor,
being careful not to open it too far, putting strain on the hinge.
#2 JOINT CONNECTOR
#3 SPRING-LOADED TAB
#4 REMOVELONG CABLE
#5 FOLDING LEGS
*FOR OMNI AND FELDENKRAIS OWNERS
: Due to the inverted truss system
installed on the underside of your table for additional strength, you cannot utilize
the shiatsu feature.
*
TO REPLACE CABLES:
Open the legs out, thread the long cable back through the
elastic string, and slide it back over the joint connector nut, until you hear a click.
CABLES MUST BE CORRECTLY RE-ATTACHED OR YOUR TABLE WILL COLLAPSE!
