Custom Audio Electronics tg2480h, User Manual

Page: 62 / 108

6.4 Printer parameters
This printer allows the coniguration of the parameters listed in the following table.
The parameters marked with the symbol D are the default values.
Settings remain active even after the printer has been turned off and they are stored in non-volatile memory.
BAUD RATE
Communication speed of the serial interface:
115200
D
19200 2400
57600 9600 1200
38400 4800
NOTE: Parameter valid only with serial interface.
DATA LENGTH
Number of bit used for characters encoding:
7 bits/car
8 bits/car
D
NOTE: Parameter valid only with serial interface.
PARITY
Bit for the parity control of the serial interface:
None D = parity bit omitted
Even = even value for parity bit
Odd = odd value for parity bit
NOTE: Parameter valid only with serial interface.
HANDSHAKING
Handshaking:
XON/XOFF
D
= software handshaking
Hardware = hardware handshaking (CTS/RTS)
NOTES:
Parameter valid only with serial interface.
When the receive buffer is full, if handshaking is set to XON/XOFF, the printer sends the XOFF (0x13) on the
serial port. When the receive buffer has cleared once again, if handshaking is set to XON/XOFF, the printer
sends the XON (0x11) on the serial port.
BUSY CONDITION
Activation mode for Busy signal:
OffLine/ RXFull = Busy signal is activated when the printer is both in OffLine status and
the buffer is full
RXFull
D
= Busy signal is activated when the buffer is full
NOTE: Parameter valid only with serial interface.
AUTOFEED
Setting of the Carriage Return character:
CR disabled
D
= Carriage Return disabled
CR enabled = Carriage Return enabled
62