5.2 Setup report
The following igure shows the setup report of the device. The shown values for parameters are sample values; for the list
and the description of device parameters see the following paragraphs.
KEYS FUNCTIONS
DEVICE
STATUS
DEVICE
PARAMETERS
PRINTER SETUP
PRINTER TYPE
= TG2460H
BOOT LOADER
= rel.1.00
BCODE =
<code>
SCODE =
<code>
HEAD VOLTAGE [V]
= 23.57
HEAD TEMP. [°C]
= 24
CUT COUNTER
= 159
POWERON COUNTER
= 100
PAPER PRINT [cm]
= 160
Printer Emul...............................:
CUSTOM/POS
Baud Rate .................................:
115200 bps
Data Length ...............................:
8 bits/chr
Parity .........................................:
None
Handshaking .............................:
Hardware
Busy Condition ..........................:
RxFull
Autofeed ....................................:
CR Disabled
USB Address N .........................:
0
Print Mode .................................:
Normal
Code Table ................................:
PC437
Chars / inch ...............................:
A=11 B=15 cpi
Speed / Quality..........................:
Normal
Print Width .................................:
56 mm
Notch Align. ...............................:
Enabled
Notch ThresH ............................:
1.25V
Notch Dist.mm. ..........................: +
00.0
Print Density..............................:
0 %
[Feed PUSH]
enter setup
[Feed FAST PUSH]
skip setup
<device name>
-
rel 1.00
PRINTER NAME and
FIRMWARE RELEASE
34