Custom Audio Electronics TFTCM112II, User Manual

Page: 42 / 48

A.1.2 Connection cables
USB cable A to B - 1,8 mt
WRDATI-USB-MM-AB-1.8-3
Male to female serial cable
DB-9 - 1,8 mt
WRDATI-RS232-9-9-18-3
A.1.3 Adjustable paper roll holder support
Paper roll holder support kit
+ NPE for 180mm paper roll
+
fi xing screws
(See chapter 4 for printer dimensions with paper roll
holder support)
PCXSP-TPTCM112
ASSEMBLY INSTRUCTION
To mount the roll holder support kit on the printer proceed as follows:
Push the adjustable fl ange in the direction indicated in the fi gure. 1.
Insert a screwdriver in the hole indicated and unscrew the paper roll holder pin in a counter-clockwise direction. 2.
Remove the paper roll holder pin. 3.
Assemble the paper roll holder pin on the support by screwing it in a clockwise direction. 4.
The printer chassis is equipped with 2 fi xing holes for the paper roll holder support. The hole marked with the let- 5.
ter A acts as a pivot, while the other hole B fastens it in the desired position. Place the paper roll holder support
on the printer chassis and fi x it with the screw in the hole marked with A.
Rotate the support in either direction to fi nd the desired position and fi x the second screw in the hole marked
6.
with B.
Remove the plug located on the near paper end connector on the back of the printer. The near paper end sensor
7.
is disabled (see fi gure). Insert the connector attached to the support into the same position.
APPENDIX A - ACCESSORIES AND SPARE PARTS
42 TPTCM112II
User Manual