Custom Audio Electronics TFTCM112II, User Manual

Page: 19 / 48

2.5.3 Cleaning the autocutter: TPTCM112II-UC-0051
To clean the autocutter, proceed as follows:
Insert a fl at-head screwdriver into the opening paper output and place the thumb on the bottom edge to protect 1.
the autocutter unit from scratches (see fi gure). Lever with the screwdriver to release the lid.
Slightly turn down the autocutter unit. 2.
Remove the protective lid of the cutter. 3.
Clean the blade with a cloth moistened with label remover. Use compressed air to remove any scratches of pa- 4.
per.
Replace the protective lid.
5.
Rotate the autocutter unit in working position. 6.
Press the FF button for at least 4 times. 7.
Send the command $1B $69 to perform a total cut. 8.
Insert a fl at-head screwdriver into the opening paper output and place the thumb on the bottom edge to protect 9.
the autocutter unit from scratches (see fi gure). Lever with the screwdriver to release the lid.
Slightly turn down the autocutter unit. 10.
Remove the protective lid of the cutter. 11.
Clean the blade with a cloth moistened with label remover. Use compressed air to remove any scratches of pa- 12.
per.
Replace the protective lid.
13.
Rotate the autocutter unit in working position. 14.
ATTENTION!
PAY CLOSE ATTENTION. THE BLADE IS VERY SHARP.
FOLLOW CAREFULLY THESE INSTRUCTIONS. IS STRICTLY FORBIDDEN ANY ACTION ON THE AUTO CUT-
TER UNIT IF THE PROTECTION LID HAS BEEN REMOVED.
2
1
2. INSTALLATION AND USE
User Manual
TPTCM112II 19