Custom Audio Electronics PP54 EVO, User Manual

Page: 50 / 88

PATH EJECT POWERON Setting of the “eject” function of the paper, with paper presence inside device during
power on:
None D = no ticket ejecting performed
Frontal = ticket ejected by front output
Rear =
ticket ejected by rear output
Bottom = ticket ejected by bottom output
TICKET IN TIMEOUT (S) Sets the time, expressed in seconds, after which the device signals the paper jam if a
ticket is held while it is being inserted into the bezel.
ALARM NEAR PAPER END Manages the low paper signal if the low paper sensor is not connected:
Activated D = low paper signal enabled
Deactivated = low paper signal disabled
FEEDER MODULE Set the feeder module type:
None = no feeder module assembled
Single Feeder/Motor D = single feeder with motor
Single Feeder/Burster = single feeder with burster
Double Feeder/Burster = double feeder with burster
SCANNER BOTTOM Set the presence of the bottom barcode reader (optional):
Not Present
D
= bottom barcode reader not present
Present = bottom barcode reader present
LED BAR FGND (RRGGBB) Set the foreground color for the status LED on the bezel. This parameter consists in
three value for red, green and blue color to be expressed in hexadecimal:
RR = from 00
D
to FF
GG = from 00 to FF
D
BB = from 00
D
to FF
LED BAR BGND (RRGGBB) Set the background color for the status LED on the bezel. This parameter consists in
three value for red, green and blue color to be expressed in hexadecimal:
RR = from 00 to FF (8F
D
)
GG = from 00
D
to FF
BB = from 00 to FF
D
PRINT DENSITY Adjusting the printing density:
-50% -12% +25%
-37% 0
D
+37%
-25% +12% +50%
NOTE: The print quality is strongly inluenced by the type of chemical treatment and
the type of storage to which the thermal paper has been subjected, as well as by the
weight of the same. It may therefore necessary to act on this parameter to obtain the
desired print quality.
50