Custom Audio Electronics KPM300, Command Reference Manual

Page: 59 / 128

n
$1D $56,
o
$1D $56
Printers: KPM300
VeriPrint
, KUBE II
VeriPrint
, KUBE-L
VeriPrint
, TK300II
VeriPrint
[Name]
Select cut mode
[Format] n ASCII GS V m
Hex 1D 56 m
Decimal 29 86 m
o ASCII GS V m n
Hex 1D 56 m n
Decimal 29 86 m n
[Range] n m = 0, 48
o m = 65, 0 ≤ n ≤ 255
[Description] Selects cut mode and executes the cut command.
m
selects cut mode as follows:
m FUNCTION
0, 48 Total cut.
65, 66 Form feed (cut po [ n × vertical motion unit]) and total cut
[Notes] • This command is only enabled if set at the beginning of the line.
• The horizontal and vertical motion units are speci fi ed by $1D $50.
[Default]
[Reference]
$1B $69, $1B $6D
[Example]
$1D $57
Printers: KPM300
VeriPrint
, KUBE II
VeriPrint
, KUBE-L
VeriPrint
, TK300II
VeriPrint
[Name]
Set printing area width
[Format] ASCII GS W nL nH
Hex 1D 57 nL nH
Decimal 29 87 nL nH
[Range] 0 ≤ nL, nH ≤ 255
0 ≤ nL + nH × 256) ≤ 832
[Description] Sets the printing area width to the area speci fi ed by
nL
and
nH
.
• The left margin is set to [(nL + nH × 256) × (horizontal motion unit)] inches.
Printable area
Left margin Printing area width
[Notes] • This command is only enabled if set at the beginning of the line.
• If the right margin is greater than the printable area, the printing area width is set at
maximum value.
• If the printing area width = 0, it is set at the maximum value.
• The horizontal and vertical motion units are speci fi ed by $1D $50. Changing the hori-
zontal or vertical motion unit does not affect the current left margin.
• The $1D $50 command can change the horizontal (and vertical) motion unit. However,
the value cannot be less than the minimum horizontal movement amount and it must be
in even units of the minimum horizontal movement amount.
ESC/POS™ Emulation
Command Reference
59