Custom Audio Electronics KPM202, User Manual, Page: 50 / 116

NOTCH/B.MARK
POSITION
Position of the alignment notch and choice of appropriate notch sensor:
Disabled D = the notch alignment is not performed
Bottom = the notch position is detected by the lower sensor (relection)
Top = the notch position is detected by the upper sensor (relection)
Transparence = the notch position is detected by both the sensors (transparence)
NOTCH/B.MARK
THRESHOLD
Threshold value (in percent) for the recognition of the presence of notch by the notch
sensor:
30% 70%
40% 80%
50% 90%
60%
D
NOTE: If the “Notch/B.Mark Position” parameter is disabled, this parameter is not printed.
NOTCH DISTANCE
“Notch Distance” is the minimum distance (in mm) between the upper edge of ticket
and the notch (see chapter 11).
The numeric value of the distance is made up with the following four parameters for the
setting of three digits (two for the integer part of the number and one for the decimal
part) and of the sign:
NOTCH DISTANCE SIGN
Sign setting:
+
D
= positive distance
- = negative distance
NOTCH DISTANCE [mm x 10]
Setting the digit for tens:
0
D
2 4 6 8
1 3 5 7 9
NOTCH DISTANCE [mm x 1]
Setting the digit for units:
0
D
2 4 6 8
1 3 5 7 9
NOTCH DISTANCE [mm x .1]
Setting the digit for decimals:
0
D
2 4 6 8
1 3 5 7 9
NOTES:
For example, to set a positive notch distance value of 15mm, modify the parameters as follows:
Notch Distance Sign = +
Notch Distance [mm x 10] = 1
Notch Distance [mm x 1] = 5
Notch Distance [mm x .1] = 0
If the “Notch/B.Mark Position” parameter is disabled, the parameters for the “Notch Distance” are not printed.
50