Worldwide Voltage Selector,
Fuse Holder and Power Switch
For optional 3+SE Footswitch
Controller Only
Switched via on/off switch or contact
closure of 25ohm to ground or better,
such as Custom Audio Electronics 4x4
or 2x4 Audio Controller, Rocktron/
Bradshaw switching systems, Rocktron
Patchmate or Rockman Octopus.
When channel 2 or channel 3 are not
switched, channel 1 is the default.
*Note, even though no harm will be done,
since channels 2 and 3 are out of phase
with each other, it is not recommended
to have them both on at the same time.
Outputs are designed to drive line level equipment. Set effects
for +4db or 0db, not -10db or -15db! Output impedance is better
than 1K, and is designed to drive a total load of 10K or higher.
The MAIN out should normally be used. The GND.LIFTED out is
provided to help solve ground loop problems in complex systems.
The AUX.IN has a 1Meg ohm input
impedance. The front panel has
priority over the rear panel AUX.IN