Page F-4
Repair and Service Manual
B
ELECTRICAL SYSTEM
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
that secures the front part of the light to the rear housing
(Ref. Fig. 3).
Remove the nuts allowing the head light assembly to be
removed from the outside of the cowl.
Disconnect the wires.
Replace with a new headlight assembly and assemble in
the reverse order of removal.
Fig. 3 Headlight & Turn Signal Light Bulb Replace-
ment
To replace the tail and brake light bulb, roll the rubber
bezel from around the edge of the taillight and remove
lens. Replace with new bulb and replace lens.
Headlight and tailight bulbs and fuses are available from
a local Distributor, an authorized Branch or the Service
Parts Department.
Fig. 4 Tail & Brake Light Bulb Replacement
FUSE REPLACEMENT
To replace fuses, locate the fuse block under the driver
side seat. Pull out old fuse and replace with a new
automotive type fuse. Headlight and taillight bulbs and
fuses are available from a local Distributor, an authorized
branch or the Service Parts Department.
Fig. 5 Ignition Switch & Fuse Block
DC TO DC CONVERTER
DC converter is secured to mounting plate with hard-
ware as shown (Ref. Fig. 6). Accessory wire harness is
connected to the DC converter. Green wire from DC
converter connects to “C” terminal of fuse block, Red
wire connects to positive (+) battery terminal, and Black
wire connects to negative (-) battery terminal.
Headlight
assembly
Turn Signal
Light
Nuts
Rear
Fender
Tail/Brake
Light
Roll Rubber
Bezel Away
From Body
STATE OF CHARGE METER AND KEY SWITCH
ON
OFF
GRN
RED
ORN/WHT
BLU/WHT
Battery BL+
(Light Switch)
(Horn Switch)
(Brake Light
Switch)
FUSE BLOCK
