32
902832
SS RADIAL
49"
7
(124.5 cm)
48
194748
MN6000
1
BRACKET
87
014387
SS LOCK
#8-32
4
NUT
88
014388
SS LOCK
10-24
1
NUT
232
010232
SS MACHINE
#8-32 x 2-1/2”
1
SCREW
(6.35 cm)
326
290326
WARNING
7
LABEL
MN
MN6000
MATCHING
1
NETWORK
4
#2 - ATTACH MATCHING
NETWORK AND RADIALS
KEY P/N DISPLAY DESC SIZE
Slide upper matching network bracket (48) onto base section
(BA). Place it tight against the fiberglass insulator. Insert one
2 1/2" screw (232) into bracket (48) and attach nut (87) as
shown in Figure E. Slide Matching Network (MN) screws into
holes on upper matching network bracket (48). Position bottom
MN bracket over captive screw in base section (BA) and
secure with #10 nut (88). Secure MN to upper MN bracket
(48) with two nuts 87). Tighten screw in upper MN bracket
(48).
The radial rods may be inserted into the base section at any
time in the assembly process.
One at a time, place the stainless radial rods (32) into the
slots in the radial rings. Tighten the corresponding ring screws
as you work your way around the rings. The radial rings do
not have to touch each other to secure the radial rods properly.
Do not overtighten the screws. When all rods are secure,
tighten all hardware on the base section. Attach jumper strap
(428) to MN screw with nut (87).
Attach warning labels (326) as shown.
FIGURE
E
R6000
87
87
MN6000
88
32
32
32
32
326
87
32
326
326
326
326
48
MN
32
232
